Specifications

Switching disable stp debug 8-113
Software Release 2.7.3
C613-03098-00 REV A
disable stp debug
Syntax DISable STP[={stp-name|ALL}] DEBug={MSG|PKT|STATE|ALL}
POrt={port-list|ALL}
DISable STP DEBug={MSG|PKT|STATE|ALL} POrt={port-list|ALL}
where:
■ stp-name is a character string 1 to 15 characters long. Valid characters are
uppercase and lowercase letters, digits, the underscore, and the hyphen.
The stp-name cannot be all.
■ port-list is a port number, range (specified as n-m), or comma-separated list
of numbers and/or ranges. Port numbers start at 1 and end at m, where m
is the highest numbered switch Ethernet port, including uplink ports.
Description This command disables STP debugging options for the specified STP or ports.
The debug parameter specifies the debugging modes that are to be disabled
(Table 8-21 on page 8-113).
A port can belong to only one STP, except on the Rapier i Series switches. If a
port is a member of multiple VLANs, then all these VLANs must belong to the
same STP.
On the Rapier i Series switches only, a port can belong to more than one STP
when the port is a member of two or more VLANs that belong to different
STPs.
If all is specified, all debugging is disabled.
The port parameter specifies the ports where the debug mode is disabled.
On the Rapier i Series switch only, the port parameter can be supplied with the
STP name. If no STP name is provided, it assumes all. On the port parameter,
the port list does not have to perfectly match all the STP port members so the
command still succeeds as a whole.
The stp parameter specifies the STP for which the debugging mode is disabled.
If an STP is specified, then the port parameter is invalid and all ports in the STP
have the debug mode disabled.
The debug status of a port is not changed if the port is moved out of its current
STP by one of the following commands: add vlan port, delete vlan port, add
stp vlan, delete stp vlan. This command is effective on disabled ports or
disabled STPs, but produces no debugging information until the ports and the
STP are enabled.
Table 8-21: STP debugging options
Option Debug Mode Description
MSG Message Decoded display of received and transmitted STP packets
PKT Packet Raw ASCII display of received and transmitted STP packets
STATE State Port state transitions.
ALL All All debug options