Install guide

46 Release Note
Rapier Switch Software Release 2.1.0
C613-10200-01 Rev A
The spanning tree algorithm can be recalculated at any time, and all timers and
counters be initialised, using the command:
RESET STP={stpname|ALL}
To show STP counters, use the command:
SHOW STP[={stpname|ALL}] COUNTER
Figure 17-16: Example output from the SHOW STP COUNTER command
Table 15: Parameters displayed in the output of the SHOW STP PORT command
Parameter Meaning
Port The number of the port.
State The state of the port; one of “Disabled”, “Blocking”,
“Listening”, “Learning” or “Forwarding”.
STP The name of the STP that the port is a member of.
STP Status The status of the STP that the port is a member of; one of
“ON” or “OFF”.
Pathcost The pathcost of the port.
Designated Cost The designated cost for the port.
Designated Bridge The unique Bridge Identifier of the switch assumed to be
the Root.
Port Priority The priority of the port.
STP Name: stp3
Receive: Transmit:
Total STP Packets ..... 0 Total STP Packets ........ 0
Configuration BPDU .... 0 Configuration BPDU .... 2618
TCN BPDU .............. 0 TCN BPDU ................. 0
Invalid BPDU .......... 0
Discarded:
Port Disabled ......... 0
Invalid Protocol ...... 0
Invalid Type .......... 0
Config BPDU length .... 0
TCN BPDU length ....... 0
Table 17: Parameters in the output of the SHOW STP COUNTER command
Parameter Meaning
Receive: Total STP Packets The total number of STP packets received. Valid STP
packets comprise Configuration BPDUs and Topology
Change Notification (TCN) BPDUs.
Receive: Configuration BPDU The number of valid Configuration BPDUs received.
Receive: TCN BPDU The number of valid Topology Change Notification BPDUs
received.
Receive:Invalid BPDU The number of invalid STP packets received.
Transmit: Configuration BPDU The number of Configuration BPDUs transmitted.