Install guide

Rapier Layer 3 Gigabit Switch Software Release 2.1.0 43
Rapier Switch Software Release 2.1.0
C613-10200-01 Rev A
Figure 16: Example output from the SHOW STP command.
Spanning Tree Protocol
------------------------------------------------------------
Name .................. stp1
VLAN members .......... vlan1 (5)
Status ................ OFF
Number of Ports ....... 2
Number Enabled ...... 0
Number Disabled ..... 2
Bridge Identifier ..... 32768 : 00-00-cd-00-a9-a5
Designated Root ....... 32768 : 00-00-cd-00-a9-a5
Max Age ............... 20
Hello Time ............ 2
Forward Delay ......... 15
Bridge Max Age ........ 20
Bridge Hello Time ..... 2
Bridge Forward Delay .. 15
Hold Time ............. 1
Name .................. default
VLAN members .......... default (1)
Status ................ ON
Number of Ports ....... 21
Number Enabled ...... 0
Number Disabled ..... 21
Bridge Identifier ..... 32768 : 00-00-cd-00-a9-a5
Designated Root ....... 32768 : 00-00-cd-00-a9-a5
Max Age ............... 20
Hello Time ............ 2
Forward Delay ......... 15
Bridge Max Age ........ 20
Bridge Hello Time ..... 2
Bridge Forward Delay .. 15
Hold Time ............. 1
Table 14: Parameters in the output of the SHOW STP command
Parameter Meaning
STP Name The name of the Spanning Tree.
VLAN members A list of the VLANs that are members of the STP. VLAN
Identifiers are shown in brackets.
Status The status of the STP; either ON or OFF.
Number of Ports The number of ports belonging to the STP.
Number Enabled The number of ports that have been enabled and are being
considered by the Spanning Tree Algorithm.
Number Disabled The number of ports that have been disabled and are not
being considered by the Spanning Tree Algorithm.
Bridge Identifier The unique Bridge Identifier of the switch. This parameter
consists of two parts, one of which is derived from the
unique Switch Address, and the other of which is the
priority of the switch.
Designated Root The unique Bridge Identifier of the bridge assumed to be
the Root.