Install guide

Rapier Layer 3 Gigabit Switch Software Release 2.1.0 31
Rapier Switch Software Release 2.1.0
C613-10200-01 Rev A
Figure 12: Tagged VLANs
To display the VLANs configured on the switch, use the command:
SHOW VLAN[={vlanname|1..4094|ALL}]
Some additional information can be displayed which may help with trouble
shooting your network. VLAN debugging mode is disabled by default, and
can be enabled for a specified time, disabled, and displayed using the
commands:
ENABLE VLAN[={vlanname|1..4094}] DEBUG={PKT|ALL}
[TIMEOUT={1..4000000000|NONE}] [OUTPUT=CONSOLE]
DISABLE VLAN[={vlanname|1..4094}] DEBUG={PKT|ALL}
SHOW VLAN DEBUG
The OUTPUT parameter set to CONSOLE specifies that the debugging
information produced is sent to the console. Use this parameter if the ENABLE
VLAN DEBUG command is used in a script. The debugging data is by default
sent to the port on which it received the ENABLE VLAN DEBUG command.
Use this option if the command is used in a script, since a script is not received
on a port.
The TIMEOUT parameter specifies the time in seconds for which any
debugging will be enabled on the specified VLAN. This reduces the risk of the
switch and the display being overloaded with too much debugging
information. This value overrides any previous VLAN debugging timeout
values for VLAN debugging, even if they were specified for other debugging
modes. If TIMEOUT is not specified, the time out is the most recent TIMEOUT
value used set in an ENABLE VLAN DEBUG command, or NONE if it has not
been previously set.
Port 3
Training VLAN VID=3
411
VLAN-FG2
Marketing VLAN VID=4Admin VLAN VID=2
Switch A
Switch B
VLAN-aware
server
Port 4Port 1
Port 2
Port 26
Port 25
Port 22
Port 21
Port 23