Install guide

Rapier Layer 3 Gigabit Switch Software Release 2.1.0 11
Rapier Switch Software Release 2.1.0
C613-10200-01 Rev A
Figure 5: Example of output from the SHOW SYSTEM command
Configuration Scripts
At boot the switch executes the commands in the boot script to configure the
switch. A boot script is a sequence of standard commands that the switch
executes at start-up. The default boot script is called
boot.cfg
, but an
alternative script file can be defined as the boot script using the command:
SET CONFIG=filename
Subsequent commands entered from the command line or executed from a
script affect only the dynamic configuration in memory, which is not retained
over a power cycle. Changes are not automatically stored in nonvolatile
memory. When the switch is restarted the configuration will be restored to that
defined by the boot script, or if the switch was restarted using the RESTART
command, any script specified in the RESTART command.
To ensure that any configuration changes made after boot are retained across a
restart or power cycle, the modified configuration must be saved as a script
file, using the command:
CREATE CONFIG=filename
The CREATE CONFIG command writes the MD5 digest, not the clear text, of
passwords in commands to the configuration file. When a configuration script is
Switch System Status Time 14:29:17 Date 12-Sep-2000.
Board ID Bay Board Name Rev Serial number
--------------------------------------------------------------------------
Base 86 AT-RP24 Rapier 24 P2-1 49867449
--------------------------------------------------------------------------
Memory - DRAM : 32768 kB FLASH : 6144 kB
--------------------------------------------------------------------------
SysDescription
CentreCOM AT-RP24 Rapier 24 version 2.1.0-00 04-Sep-2000
SysContact
SysLocation
SysName
SysUpTime
30262 ( 00:05:02 )
Software Version: 2.1.0-00 04-Sep-2000
Release Version : 2.1.0-00 04-Sep-2000
Release built : Sep 12 2000 at 14:28:59
Patch Installed : NONE
Territory : usa
Help File : help.hlp
Main PSU : On Main Fan : On
RPS Monitor : On RPS Connected : Yes
RPS PSU : On RPS Fan : On
Boot configuration file: vts.cfg (exists)
Current configuration: vts.cfg
Security Mode : Disabled
Warning (248283): No patches found.