Install guide

28 Release Note
Software Release 2.6.4
C613-10404-00 REV A
Extended Syslog Format
A new parameter, syslogformat, has been added to the create log output and
set log output commands:
create log output={temporary|permanent|output-id}
destination={email|memory|asyn|router|syslog}
[syslogformat=extended|normal] [other-parameters...]
set log output={temporary|permanent|output-id}
[syslogformat=extended|normal] [other-parameters...]
The permanent option for the output parameter is not available on AT-8600 Series
switches.
The syslogformat parameter specifies whether or not the log messages sent to
the syslog server contain the date, time and system name. If the parameter is
set to extended the date, time and system name are included. If the parameter
is set to normal the date, time and system name are not included in the syslog
message. This parameter is only valid if destination is syslog. The default is
normal.
Yes secure manager show system (without current configuration file)
show files
show install
show release
show interface
show ip interface
show ip arp
show ip route full
show ip count
show switch (AR400, AT-8700XL, AT-8800, Rapier and
Rapier i series)
show switch counter (AR400, AT-8700XL, AT-8800,
Rapier and Rapier i series)
show switch fdb (AR450, AT-8700XL, AT-8800, Rapier
and Rapier i series)
show startup
show flash
show switch port=all (AR400, AT-8700XL, AT-8800,
Rapier and Rapier i series)
show switch port=all counter (AR450, AT-8700XL,
AT-8800, Rapier and Rapier i series)
show buffer scan
show cpu
show log
show exception
show ffile check
Table 5: The list of show commands that are executed by the show debug command, when the full parameter is or is not
specified, under different combinations of security mode and privilege level (Continued)
Full parameter specified? Security mode Privilege level List of commands executed