Install guide

26 Release Note
Software Release 2.6.4
C613-10404-00 REV A
Extended Show Debug Command
The command show debug displays the output of a list of other show
commands. A full parameter has been added and displays a longer list of
commands:
show debug [stack|full]
The output also depends on the switch’s security mode and the user’s
privileges. The possible command list variations are given in Table 5 on
page 26.
The stack parameter limits the output to a stack dump, if one is available. The
output depends on whether the last fatal condition was a hardware reset or a
software reboot. After a software reboot, the output is a stack dump. After a
hardware reset, no stack dump information is available and a message to this
effect is displayed. If the stack parameter is not specified, both a stack dump if
available and the output of a list of show commands is generated.
Table 5: The list of show commands that are executed by the show debug command, when the full parameter is or is not
specified, under different combinations of security mode and privilege level
Full parameter specified? Security mode Privilege level List of commands executed
No normal manager
show system
show files
show install
show feature (AR400, AR700, AT-8800, Rapier and
Rapier i series)
show release
show config dynamic
show buffer scan
show cpu
show log
show exception
show ffile check
No secure security officer
No secure manager show system (without current configuration file)
show files
show install
show release
show buffer scan
show cpu
show log
show exception
show ffile check