Install guide

24 Release Note
Software Release 2.6.4
C613-10404-00 REV A
Virtual Bridge (VLAN) MIB
Support has been added for RFC 2674, “Definitions of Managed Objects for
Bridges with Traffic Classes, Multicast Filtering and Virtual LAN Extensions”
which defines MIB objects for managing IEEE 802.1Q VLANs. Objects defined
in this MIB reside in the mib(1) sub-tree (Figure 4 on page 24), under the
dot1dBridge sub-tree defined in RFC 1493, and have the object identifier
qBridgeMIBObjects ({ mib-2 dot1dBridge(17) qBridgeMIB(7) 1 }).
Figure 4: The Virtual Bridge (VLAN) sub-tree of the Internet-standard Management Information Base (MIB)
The MIB is organised into four logical groups:
■ The dot1qBase Group contains general objects that apply to any device that
supports IEEE 802.1Q VLANs.
■ The dot1qTp Group contains objects that describe the operation and status
of transparent bridging, including the dynamic filtering databases for
unicast and multicast forwarding.
■ The dot1qStatic Group contains objects that describe static configurations
for transparent bridging, including static entries in the filtering databases
for unicast and multicast forwarding.
■ The dot1qVlan Group contains objects that describe the configuration and
status of VLANs, including statically configured VLANs and VLANs
configured dynamically by protocols like GVRP.
The following objects are implemented:
■ All objects in the dot1qBase Group.
■ The dot1qVlanNumDeletes object in the dot1qVlan Group.
■ The dot1qVlanCurrentTable object in the dot1qVlan Group.
■ The dot1qVlanStaticTable object in the dot1qVlan Group.
■ The dot1qNextFreeLocalVlanIndex object in the dot1qVlan Group.
■ The dot1qPortVlanTable object in the dot1qVlan Group.
egp (8)
cmot (9) snmp (11)
mib (1)mib (1)
internet (1)
enterprises (1)
directory (1)
private (4)
experimental (3)mgmt (2)
appletalk (13)
ospf (14) rmon (16)
dot1dBridge (17)
MIB12
qBridgeMIB (7)
bgp (15)
qBridgeMIBObjects (1)
ifExtensions (12)
transmission (10)