Install guide

Software Release 2.6.4 17

Software Release 2.6.4

C613-10404-00 REV A

Enable IPV6 MLD Interface Command

This enhancement is available on AT-8800, Rapier, and Rapier i Series switches.

This command lets users enable the Multicast Listener Discovery (MLD)

protocol on an interface that already exists. For Release 2.6.4, the v1compatible

parameter for the command has been replaced with the queryversion

parameter. The new syntax is:

enable ipv6 mld interface=interface [queryversion={1|2}]

where interface is a valid interface

Queryversion specifies the version of MLD Query to us on the interface. It is a

more accurate way to specify interoperability between MLDv2 and MLDv1.

The default is 2.

To avoid unnecessary error messages, we recommend that users replace

v1compatible with queryversion along with their related values in scripts

currently being used. For more information about Multicast Listener

Discovery, see the IPv6 Multicasting chapter of the Software Reference.

Text Message at Login (Welcome banner)

Before users get the prompt that lets them log in, contents from a file named

various kinds of messages be sent to users. The following diagram is an

example of output from the

and Rapier i series switches.

The following diagram is an example of output from the

AT-8600 series switch.

INFO: Self tests beginning.

INFO: RAM test beginning.

PASS: RAM test, 65536k bytes found.

INFO: BBR tests beginning.

…………

INFO: Switch startup complete

Warning: This equipment is for authorised persons only. If you

do not have proper clearance, please logout now.