Install guide

86 Firewall Enhancements Release Note
Software Version 2.9.1
C613-10486-00 REV C
Example To display information about every SIP client currently managed by the SIP
ALG, use the command:
sh fire sipa auto
First registration time Time and date that the client first registered with the SIP
Registrar using this session. The same session is used each
time the SIP client re-registers with the SIP Registrar, unless
the session expires. The session should not expire unless the
client does not re-register with the SIP Registrar within the
expiry time limit set by the registrar.
Seconds to expiry Time remaining until the client’s existing registration expires
with the SIP Registrar. The session is deleted if the client
does not re-register before this time runs out.
Table 13: Parameters in the output of the show firewall sipalg autoclients command
Parameter Meaning