Install guide

82 Firewall Enhancements Release Note
Software Version 2.9.1
C613-10486-00 REV C
Example To display the configuration of limit rule 1 of firewall policy “Nerv_ office”, use
the command:
sh fire poli=Nerv_office lim=1
Figure 15: Example output from the show firewall policy limitrule detail command
Policy=Nerv_office
-----------------------------------------------------------
Limitrule 1
-----------------------------------------------------------
Interface ................... vlan1
IP .......................... 202.36.164.113
GBL Remote IP ............... all
Source IP Limit ............. 1
-----------------------------------------------------------
Per Source IP Count
Source IP Address Active Sessions
202.36.164.113 ............ 1
-----------------------------------------------------------
Limitrule 2
-----------------------------------------------------------
Interface ................... all
IP .......................... all
GBL Remote IP ............... all
Source IP Limit ............. 12
-----------------------------------------------------------
Per Source IP Count
Source IP Address Active Sessions
101.111.12.13 ............. 5
101.111.12.1 .............. 12
202.36.164.113 ............ 1
Table 11: Parameters in output of the show firewall limitrule detail command
Parameter Meaning
Policy Name of the policy that the limit rules apply to.
Limitrule Rule identification number for the limit rule.
Interface Interface that the rule applies to.
IP IP address or address range of the private devices that sessions
are limited for.
GBL Remote IP IP address or address range of the public devices that sessions
are limited for.
Source IP Limit Maximum number of active sessions matching this limit rule
that a device can have.
Per Source IP Count Summary of any current matching sessions a device has for the
limit rule.
Source IP Address IP address of the device that initiated the session.
Active Sessions Current number of active session initiated by the device.