Install guide

Software Version 2.9.1 67
Software Version 2.9.1
C613-10486-00 REV C
To show details about the flash file and the current client sessions that the SIP
ALG has, use the commands:
show firewall sipalg autoclients[=session-number] [summary]
show firewall sipalg autoclients ip=ipadd[-ipadd] [summary]
To delete the current details in the client database, use the command:
reset firewall sipalg autoclients
Resetting the database does not delete any established SIP sessions.
In an AR400 or AR700 Series router with the flash autowrite feature disabled,
the SIP ALG will not be able to create a static copy of the client database. To
enable this feature, use the command:
enable flash autowrite
If you disable flash autowrite while the SIP ALG is in automatic mode, then the
SIP ALG will no longer be able to write to the client database, but the file will
still remain on the flash. To delete the file, use the command:
delete file=fwsipmap.sip
Command Changes
The following table summarises the new and modified commands:
Setting a Trigger for Automatic Client Management
This Software Version allows you to set a firewall trigger to run a script when
the SIP ALG reaches the limit for the number of SIP clients it can support in
automatic mode. To create the trigger, use the new sipautomax parameter in
the command:
create trigger=trigger-id firewall=sipautomax mode=start
[other-options]
To modify the trigger, use the command:
set trigger=trigger-id firewall=sipautomax mode=start
[other-options]
Command Change
reset firewall sipalg autoclients New command
set firewall sipalg New mode parameter
New maxautoclients parameter
New multiservers parameter
show firewall sipalg New Mode field in output
New Maximum automatic clients field in output
New Multiple servers field in output
show firewall sipalg autoclients New command