Install guide

64 IPv6 Enhancements Release Note
Software Version 2.9.1
C613-10486-00 REV C
create ipv6 interface
Syntax CREate IPV6 INTerface=interface [DUPtrans=1..16]
[METric=1..16] [RETRans=0..4294967295]
Description This command creates an IPv6 Ethernet interface and uses stateless address
autoconfiguration to assign it a link-local address.
The new metric parameter specifies the cost to RIPv6 for crossing the logical
interface. This parameter is allowed only on link-local interfaces. Therefore,
setting this parameter also sets metrics for all logical interfaces over the same
IPv6 interface to the same value. The default is 1.
set ipv6 interface
Syntax SET IPV6 INTerface=interface [FILter=0..99]
[IPaddress=ipv6add/prefix-length] [METric=1..16]
[PREFerred=1..4294967295|INFinite]
[PRIorityfilter=200..299]
[PUBlish={YES|NO|ON|OFF|True|False}]
[VALid=1..4294967295|INFinite]
Description This command modifies values associated with an interface that was created
by either the create ipv6 interface or add ipv6 interface command.
The new metric parameter specifies the cost to RIPv6 for crossing the logical
interface. This parameter is allowed only on link-local interfaces. Therefore,
setting this parameter also sets the metrics for all logical interfaces over the
same IPv6 interface to the same value. The default is 1.
show ipv6 route
Syntax SHow IPV6 ROUte [FULL]
Description This command displays the contents of the IPv6 route table. The full parameter
displays all the routes in the IPv6 route table. When the full parameter is not
specified, then the command displays a subset of the routing table that
includes:
■ all static routes
■ all interface routes
■ only the RIP routes that are alive and best