Install guide

44 Internet Protocol (IP) Enhancements Release Note
Software Version 2.9.1
C613-10486-00 REV C
show ip interface
Syntax SHow IP INTerface[=interface] [COUnter[=MULticast]]
Description This command displays interface configuration information for interfaces
assigned to the IP module with the add ip interface command. The new GArp
field displays whether or not the interface accepts gratuitous ARPs. The PArp
field now displays Loc when local proxy ARP is enabled on the interface.
Figure 8: Example output of the show ip interface command from an AT-8600 Series switch
Interface Type IP Address Bc Fr PArp Filt RIP Met.
Pri. Filt Pol.Filt Network Mask MTU VJC GRE OSPF Met. DBcast Mul.
GArp
--------------------------------------------------------------------------------
LOCAL - Not Set - n Def --- - - ---
--- ---- - - - --- - - ---
On
Loopback 192.168.10.100 - n - --- - - ---
--- --- - - - --- - - ---
On
vlan2 Static 192.168.1.1 1 n Loc --- 01 Pass No
--- --- 255.255.255.0 1500 - --- 0000000001 No Rec
On
vlan3# Static 192.168.2.1 1 n Loc --- 01 Pass No
--- --- 255.255.255.0 1500 - --- 0000000001 No Rec
Off
--------------------------------------------------------------------------------
Table 5: New and modified parameters in the output of the show ip interface command
Parameter Meaning
PArp Whether this interface supports proxy ARP and if ARP responses will be
generated if a default route exists; one of “On” (respond to ARP Requests
only if a specific route exists), “Loc” (responds to ARP Requests if a specific
route exists, including ARP requests for hosts within a subnet) “Off”, or
“Def” (respond to ARP Requests if a specific route or a default route
exists).
GArp Whether the interface accepts or rejects gratuitous ARP messages; one of
“On” or “Off”.