Install guide

MAC-Forced Forwarding show macff interface counter 25
Example To see the counters for ports 2 to 10, 14 and 18, on vlan5 use the command:
show macff int=vlan5 po=2-10,14,18
See Also disable macff interface
enable macff interface
reset macff counter
show macff
show macff interface
Active Servers Number of ARs and ASs in use by clients on this VLAN.
Debugging Debugging modes that are enabled on the VLAN.
Counters for Port: Specific port that the counters are for.
ARP Counters
Requests Number of ARP Requests received by MAC-Forced Forwarding
from clients on this port.
Replies Number of ARP Replies that MAC-Forced Forwarding has sent
to clients on this port on behalf of an AR or AS.
Resolution Requests Number of ARP Resolution Requests from clients on this port
for an AR or AS that required MAC address resolution.
Resolutions Failed Number of ARP Requests from clients on this port that failed
to determine the MAC address of the AR or AS.
Src : No DHCPSN Entry Number of ARP requests from clients on this port, where the
source client is not in the DHCP snooping database.
Src : Inconsistent Data Number of ARP requests from clients on this port where the
source client information in the DHCP snooping database does
not match the source client information in the ARP request.
Src : No Routers Number of ARP requests from clients on this port where the
source client does not have a valid AR in the DHCP snooping
database.
Src : No Routers Found Number of ARP requests from clients on this port where
MAC-Forced Forwarding could not contact any of the valid
ARs for that client.
Dest : No DNCPSN Entry Number of ARP requests sent from clients on this port to
another client within the same subnet, where the destination
client is not in the DHCP snooping database. The switch drops
these requests.
S/D : Same Port Number of ARP requests from clients on this port where the
source and destination clients are on the same port (within a
private network). The switch drops these requests.
Table 4: Parameters in the output of the show macff interface counter command (cont.)
Parameter Meaning