Install guide

40 show lldp neighbour Software Reference
show lldp neighbour
Syntax SHow LLDP NEIghbour [POrt={ALL|port-list}] [DETail]
Description This command displays information about neighbours discovered on the
specified ports. If no optional parameters are specified, information about all
LLDP neighbours is displayed.
Figure 7: Example output from the show lldp neighbour port=1,2 command
Parameter Description
POrt The ports for which to display LLDP neighbour information, either
a list of ports or all ports.
port-list can be any/all of the following:
• a single switch port number. Port numbers start at 1 and end
at m, where m is the highest numbered port.
• a range of switch port numbers (specified as n-m).
• a comma-separated list of switch port numbers and/or ranges.
• a single Ethernet interface (specified as ethn).
• a comma-separated list of Ethernet interfaces. Ethernet port
numbers start at eth0 and end at ethn, where n is the highest
numbered Ethernet port.
• the Ethernet interface eth0.
Default: all.
DETail Specify detail to display additional, detailed LLDP neighbour
information about the specified ports or all ports.
LLDP neighbour information
Port 1:
There are no neighbours for this port.
Port 2:
remoteIndex timeMark chassisId sysName
------------------------------------------------------------
1 89148 00-30-84-6e-ba-c2 switch1