Install guide

Link Layer Discovery Protocol (LLDP) show lldp 35
Examples To display the LLDP configuration information about port 1 and 3 in detail, use
the command:
sh lldp po=1,3 det
To display the LLDP configuration information with local system data about
port 1 to 3 in summary, use the command:
sh lldp locald po=1,3
See Also disable lldp port
enable lldp port
show lldp counters
show lldp neighbour
adminStatus The LLDP transmission and reception status of the port, one
of:
• txOnly
Transmission is enabled only
• rxOnly
Reception is enabled only
• txAndrx
Both transmission and reception are enabled
• disabled
Both transmission and reception are disabled
You can enable a value of txOnly, rxOnly, or txAndrx for
the port using the enable lldp port command. You can
disable txOnly, rxOnly, or txAndrx for the port using the
disable lldp port command.
Notifications The current notifications setting, either ‘enabled’ or
‘disabled’. You can set this using the disable lldp
notifications or enable lldp notifications commands.
LLDP optional TLVs
Port description The port description TLV advertisement status, either
‘advertise’ or ‘not advertise’.You can set this using the
disable lldp portdescription or enable lldp
portdescription commands.
System name The system name TLV advertisement status, either
‘advertise’ or ‘not advertise’.You can set this using the
disable lldp systemname or enable lldp systemname
commands.
System description The system description TLV advertisement status, either
‘advertise’ or ‘not advertise’.You can set this using the
disable lldp systemdescription or enable lldp
systemdescription commands.
System capabilities The system capabilities TLV advertisement status, either
‘advertise’ or ‘not advertise’.You can set this using the
disable lldp systemcapabilities and enable lldp
systemcapabilities commands.
Management address The management address TLV advertisement status, either
‘advertise’ or ‘not advertise’.You can set this using the
disable lldp managementaddress or enable lldp
managementaddress commands.
Table 1: Parameters in output of the show lldp command (cont.)
Parameter Meaning