Install guide

Software Version 2.9.1 25
Software Version 2.9.1
C613-10486-00 REV C
show shdsl linedetails
Syntax SHow SHDsl={interface|ALL} LINEdetails
Description This command displays the current negotiated configuration information for
the specified SHDSL interface or all SHDSL interfaces. If the SHDSL interface is
not in the data state, the parameters displayed in the output are the last
received or known parameters for the connection.
Figure 2: Example output from the show shdsl linedetails command
SHDSL Line Details
-------------------------------------------------------------------------------
shdsl0:
Pair 1 Pair 2
------ ------
Standard .................... Annex A Annex A
Pair mode ................... 2 pair standard 2 pair standard
.
.
.
Table 1: New parameters in the output of the show shdsl linedetails command
Parameter Meaning
Pair mode Whether the SHDSL line is operating in 1-pair or 2-pair
mode, and if in 2-pair mode whether it is in
standards-based or enhanced mode.