Install guide

Link Layer Discovery Protocol (LLDP) show lldp 29
show lldp
Syntax SHow LLDP [LOCALData] [POrt={ALL|port-list}] [DETail]
Description This command displays information about your LLDP configuration. If no
optional parameters are specified, the global LLDP configuration is displayed.
Parameter Description
LOCALData Displays additional LLDP local system data for the specified ports,
or all ports if you do not specify the port parameter.
POrt The ports for which to display LLDP information, either a list of
ports or all ports.
port-list can be any/all of the following:
• a single switch port number. Port numbers start at 1 and end
at m, where m is the highest numbered port.
• a range of switch port numbers (specified as n-m).
• a comma-separated list of switch port numbers and/or ranges.
• a single Ethernet interface (specified as ethn).
• a comma-separated list of Ethernet interfaces. Ethernet port
numbers start at eth0 and end at ethn, where n is the highest
numbered Ethernet port.
• the Ethernet interface eth0.
Default: all
DETail Displays additional, detailed LLDP port configuration information
about the specified ports (Figure 3, Table 1).