Install guide

28 set lldp txhold Software Reference
set lldp txhold
Syntax SET LLDP TXHold=2..10
Description This command changes the default value of the LLDP MIB object
lldpMessageTxHoldMultiplier. For more information, see Section 12 of the
IEEE Standard 802.1AB-2005.
The txhold parameter specifies the multiplier on the msgTxInterval parameter
of the set lldp txinterval command. The default is 4. Changing the default can
affect LLDP operation.
Example To set the txhold value to 8, use the command:
set lldp txh=8
See Also set lldp reinitdelay
set lldp txdelay
set lldp txinterval
show lldp
set lldp txinterval
Syntax SET LLDP TXInterval=5..32768
Description This command sets the time interval between LLDP transmissions. This is the
LLDP MIB object lldpMessageTxInterval. For more information, see
Section 12 of the IEEE Standard 802.1AB-2005.
The txinterval parameter specifies the number of seconds that the switch
transmits LLDPDUs on behalf of the LLDP agent. The default is 30. Note that
changing the default can affect LLDP operation.
Example To set the LLDP to transmit LLDPDUs every 100 seconds, use the command:
set lldp txi=100
See Also set lldp reinitdelay
set lldp txdelay
set lldp txhold
show lldp