Install guide

Link Layer Discovery Protocol (LLDP) set lldp txdelay 27

set lldp txdelay

Syntax SET LLDP TXDelay=1..8192

Description This command changes the default time delay between successive LLDP

transmissions initiated by value or status changes in the local LLDP MIB. For

more information, see Transmission delay timer on page 5.

This is the LLDP MIB object lldpTxDelay. For more information, see Section 12

of the IEEE Standard 802.1AB-2005.

The txdelay parameter is the number of seconds that the switch waits between

transmitting successive LLDPDUs, when those LLDPDUs are initiated by

value or status changes in the local LLDP MIB. The default is 2. Changing the

default can affect LLDP operation.

Example To set the transmission delay to 10 seconds, use the command:

set lldp txd=10