Install guide

24 enable lldp systemname Software Reference
enable lldp systemname
Syntax ENAble LLDP SYSTEMName [POrt={ALL|port-list}]
Description This command enables system name TLV advertisement on the specified ports.
The LLDP agent now includes local system name information in any
LLDPDUs it sends.
Use the port parameter to specify the ports for which to enable system name
TLV advertisement, either a list of ports or all ports. port-list can be any/all of
the following:
■ a single switch port number. Port numbers start at 1 and end at m, where m
is the highest numbered port.
■ a range of switch port numbers (specified as n-m).
■ a comma-separated list of switch port numbers and/or ranges.
■ a single Ethernet interface (specified as ethn).
■ a comma-separated list of Ethernet interfaces. Ethernet port numbers start
at eth0 and end at ethn, where n is the highest numbered Ethernet port.
■ the Ethernet interface eth0.
By default, LLDP system name advertisement is enabled for all ports.
Examples To enable system name advertisement on port 1 and 2, use the command:
ena lldp systemn po=1,2
To enable system name advertisement on all ports, use one of the commands:
ena lldp systemn
ena lldp systemn po=all
See Also disable lldp systemname
enable lldp port
show lldp
purge lldp
Syntax PURge LLDP
Description This command clears your existing LLDP configuration information and all
remote LLDP MIB data. LLDP reverts to its default configuration, which means
that LLDP is disabled for all ports.
This command does not reset LLDP MIB counters because these counters
cannot be reset.
Example To purge your LLDP configuration and remote LLDP data, and restore the
default values, use the command:
pur lldp
See Also reset lldp
show lldp