Install guide

22 enable lldp systemcapabilities Software Reference
enable lldp systemcapabilities
Syntax ENAble LLDP SYSTEMCapabilities [POrt={ALL|port-list}]
Description This command enables system capabilities TLV advertisement on the specified
ports. System capabilities are the primary functions of your system, including
bridge and/or switch. The LLDP agent now includes system capabilities
information in any LLDPDUs it sends.
Use the port parameter to specify the ports for which to enable system
capability TLV advertisement, either a list of ports or all ports. port-list can be
any/all of the following:
■ a single switch port number. Port numbers start at 1 and end at m, where m
is the highest numbered port.
■ a range of switch port numbers (specified as n-m).
■ a comma-separated list of switch port numbers and/or ranges.
■ a single Ethernet interface (specified as ethn).
■ a comma-separated list of Ethernet interfaces. Ethernet port numbers start
at eth0 and end at ethn, where n is the highest numbered Ethernet port.
■ the Ethernet interface eth0.
By default, LLDP system capabilities advertisement is enabled for all ports.
Examples To enable system capabilities advertisement on ports 1 and 2, use the
command:
ena lldp systemc po=1,2
To enable system capabilities advertisement on all ports, use one of the
commands:
ena lldp systemc
ena lldp systemc po=all
See Also disable lldp systemcapabilities
enable lldp port
show lldp