Install guide

Link Layer Discovery Protocol (LLDP) enable lldp notifications 19

enable lldp notifications

Syntax ENAble LLDP NOTIfications [POrt={ALL|port-list}]

Description This command enables the switch to send LLDP SNMP notifications from the

specified ports. Notifications are SNMP traps, triggers, and logs.

Use the port parameter to specify the ports for which to enable LLDP

notifications, either a list of ports or all ports. port-list can be any/all of the

following:

■ a single switch port number. Port numbers start at 1 and end at m, where m

is the highest numbered port.

■ a range of switch port numbers (specified as n-m).

■ a comma-separated list of switch port numbers and/or ranges.

■ a single Ethernet interface (specified as ethn).

■ a comma-separated list of Ethernet interfaces. Ethernet port numbers start

at eth0 and end at ethn, where n is the highest numbered Ethernet port.

■ the Ethernet interface eth0.

By default, LLDP notifications are disabled for all ports.

To set the amount of time between notifications, use set lldp notification

interval command on page 26.

Examples To enable LLDP notifications from ports 1 and 2, use the command:

ena lldp noti po=1,2

To enable LLDP notifications from all ports, use one of the commands:

ena lldp noti

ena lldp noti po=all