Install guide

18 enable lldp managementaddress Software Reference

enable lldp managementaddress

Syntax ENAble LLDP MANAgementaddress [POrt={ALL|port-list}]

Description This command enables management address TLV advertisement on the

specified ports. The LLDP agent now includes management address

information in any LLDPDUs it sends.

By default, the managementaddress is the MAC address of the switch. To

advertise the IPv4 management address of the local LLDP agent instead, use

the set lldp managementaddress command.

Use the port parameter to define the ports for which to enable management

address TLV advertisement, either a list of ports or all ports. port-list can be

any/all of the following:

■ a single switch port number. Port numbers start at 1 and end at m, where m

is the highest numbered port.

■ a range of switch port numbers (specified as n-m).

■ a comma-separated list of switch port numbers and/or ranges.

■ a single Ethernet interface (specified as ethn).

■ a comma-separated list of Ethernet interfaces. Ethernet port numbers start

at eth0 and end at ethn, where n is the highest numbered Ethernet port.

■ the Ethernet interface eth0.

By default, LLDP management address advertisement is enabled for all ports.

Examples To enable management address advertisement on ports 1 and 2, use the

command:

ena lldp mana po=1,2

To enable management address advertisement on all ports, use one of the

commands:

ena lldp mana

ena lldp mana po=all