Install guide

12 disable lldp notifications Software Reference

disable lldp notifications

Syntax DISable LLDP NOTIfications [POrt={ALL|port-list}]

Description This command stops the switch from sending LLDP SNMP notifications from

the specified ports. Notifications are SNMP traps, triggers, and logs.

Use the port parameter to specify the ports for which to disable LLDP

notifications, either a list of ports or all ports. port-list can be any/all of the

following:

■ a single switch port number. Port numbers start at 1 and end at m, where m

is the highest numbered port.

■ a range of switch port numbers (specified as n-m).

■ a comma-separated list of switch port numbers and/or ranges.

■ a single Ethernet interface (specified as ethn).

■ a comma-separated list of Ethernet interfaces. Ethernet port numbers start

at eth0 and end at ethn, where n is the highest numbered Ethernet port.

■ the Ethernet interface eth0.

By default, LLDP notifications are disabled for all ports.

To set the amount of time between notifications, use set lldp notification

interval command on page 26.

Examples To stop the switch from sending LLDP notifications from ports 1 and 2, use the

command:

dis lldp noti po=1,2

To stop the switch from sending LLDP notifications from all ports, use one of

the commands:

dis lldp noti

dis lldp noti po=all