Install guide

120 show pim staterefresh Software Reference
show pim staterefresh
Syntax SHow PIM STATerefresh
Description This command displays the internal State Refresh table for PIM-DM (Figure 29,
Table 20).
Figure 29: Example output from the show pim staterefresh command
Examples To display the internal State Refresh table, use the command:
sh pim stat
Related Commands disable pim
enable pim
set pim
show pim
PIM4 Dense Mode State Refresh
-----------------------------------------------------------
Source .............................. 172.95.2.1
Group ............................... 238.1.2.3
Originator state .................. Orginator
Direct Connect to source on .....
Source alive timer .............. 200
State refresh timer ............. 50
Source .............................. 172.96.2.1
Group ............................... 238.1.2.3
Originator state .................. Not Originator
Table 20: Parameters in output of the show pim staterefresh command
Parameter Meaning
Source IP address of the multicast sender.
Group IP address of the multicast group.
Originator state Whether the switch can act as a state refresh message
originator. A switch acts as an originator when the source is
directly connected.
Direct Connect to source on Interface to which the source is connected.
Source alive timer An alive timer in seconds for directly connected sources. A
zero value indicates that the timer is not running because
no data is being received.
State refresh timer Time in seconds before the next state refresh message is
sent.