Install guide

118 show pim rpset Software Reference
show pim rpset
Syntax SHow PIM RPSet
Description This command displays the static group-to-RP mapping (Figure 27, Table 18),
followed by the elected bootstrap router’s current set of RP candidates and the
groups they are configured for (Figure 28, Table 19). It applies to PIM-SM only.
Figure 27: Example output from the show pim rpset command when the RP is statically
configured
Figure 28: Example output from the show pim rpset command when the RP is determined
using the bootstrap mechanism
PIM4 Static RP Mapping
------------------------------------------------------------
RP Address .......................... 192.168.2.1
Group address/Mask ................ 239.1.0.0 /
255.255.0.0
Table 18: Parameters in output of the show pim rpset command when the RP is
statically configured
Parameter Meaning
RP address IP address of the router that is statically configured as the RP
for the following group(s).
Group address IP address of the multicast group.
Mask Mask for the multicast group address.
PIM4 RP Set Information
--------------------------------------------------------
Group address/Mask ........ 224.1.1.1 / 255.255.255.255
RP Candidate address .. 192.168.1.1
Priority ............ 192
Holdtime ............ 120
RP Candidate address .. 192.168.2.1
Priority ............ 180
Holdtime ............ 120
Table 19: Parameters in output of the show pim rpset command when the RP is
determined using the bootstrap mechanism
Parameter Meaning
Group address IP address of the multicast group.
Mask Mask for the multicast group address.
RP Candidate address IP addresses of each RP candidate for the multicast group
and mask pair.
Priority Priority for the RP candidate to become the RP. A candidate
with a lower priority is more likely to become the RP.