Install guide

IP Multicasting show pim rpcandidate 117
show pim rpcandidate
Syntax SHow PIM RPCandidate
Description This command displays information about multicast groups for which the
switch is a PIM-SM rendezvous point candidate (Figure 26, Table 17).
Figure 26: Example output from the show pim rpcandidate command
Examples To display information about multicast groups for which the switch is a
rendezvous point candidate, use the command:
sh pim rpc
Related Commands add pim rpcandidate
delete pim rpcandidate
disable pim
enable pim
set pim
set pim rpcandidate
show pim
PIM4 RP Candidate
------------------------------------------------------------
Priority ....................... 192
Interface .......................vlan1
Group address/Mask ........... 224.1.1.1 / 255.255.255.255
Group address/Mask .......... 224.2.2.0 / 255.255.255.0
Table 17: Parameters in output of the show pim rpcandidate command
Parameter Meaning
Priority Priority for the switch to become the rendezvous point for
any multicast groups.
Group Address Multicast groups associated with the specified rendezvous
point.
Mask Mask for the address.
Interface Interface the switch advertises itself as when advertising as
a rendezvous point for multicast groups.