Install guide

IP Multicasting show pim route 111
show pim route
Syntax SHow PIM ROUte
Description This command displays information about the internal PIM routing table, for
PIM Sparse Mode (Figure 23, Figure 24 on page 112, Table 15 on page 112)
and/or Dense Mode (Figure 25 on page 115, Table 16 on page 115).
Figure 23: Example output from the show pim route command for PIM Sparse Mode,
when the switch is the RP
PIM4 Sparse Mode Tree Information Base
------------------------------------------------------------
Group ............................ 224.1.1.1
Type ........................... (*,G)
RP Address ................... I am the RP
Expiry time .................. 630
Join/prune time .............. 0
Immediate output interfaces ..
Type ........................... (S,G)
Source ....................... 192.168.0.1
RPF Neighbour to Src ......... 192.168.1.1
RPF Interface to Src .........
Expiry time .................. 180
Keepalive time ............... 160
Join/prune time .............. 0
Register time ................ 0
SPT bit ...................... Unset
Inherited output interfaces ..
Immediate output interfaces .. None
Type ........................... (S,G,rpt)
Source ....................... 192.168.0.1
RP Address ................... I am the RP
Expiry time .................. 180
Override time ................ 0
Inherited output interfaces ..
Type ........................... (*,*,RP)
RP Address ................... I am the RP
Expiry time .................. 210
Join/prune time .............. 0
Immediate output interfaces .. None