Install guide

110 show pim neighbour Software Reference
show pim neighbour
Syntax SHow pim NEIghbour
Description This command displays information about the PIM Neighbour Table
(Figure 21, Figure 22, Table 14).
Figure 21: Example output from the show pim neighbour command for PIM Sparse Mode
Figure 22: Example output from the show pim neighbour command for PIM Dense Mode
Examples To display information about the PIM Neighbour Table, use the command:
sh pim nei
Related Commands disable pim
enable pim
set pim
PIM4 Sparse mode Neighbour Table
------------------------------------------------------------
Interface ........................
IP Address ..................... 137.39.3.93
DR Priority .................. 1
Neighbour Liveness Timer ..... 82
PIM4 Dense mode Neighbour Table
------------------------------------------------------------
Interface ........................
IP Address ..................... 192.168.57.2
Neighbour Liveness Timer ..... 105
Is state refresh capable ..... No
Table 14: Parameters in output of the show pim neighbour command
Parameter Meaning
Interface Interface to which the PIM neighbour is connected.
IP Address IP address of the neighbour.
DR Priority Priority for this neighbour to become the designated router
for the subnetwork.
Neighbour Liveness Timer Time in seconds until the neighbour is removed from the
neighbour table.
Is state refresh capable Whether the neighbour originates and processes State
Refresh messages for PIM-DM.