Install guide

98 show ip mvr Software Reference
show ip mvr
Syntax SHow IP MVR [VLAN=1..4094]
Description This command displays all information about MVR on the switch (Figure 11,
Table 8).
The vlan parameter specifies the VLAN identifier of the multicast VLAN to be
displayed. If none is provided, all multicast VLANs on the switch are
displayed.
Figure 11: Example output from the show ip mvr command
Examples To show information for multicast VLAN number 22, use the command:
sh ip mvr vlan=22
Related Commands show ip mvr counter
Multicast VLAN
--------------------------------------------------------------------------------
VLAN Mode Imtleave Source Ports Receiver Ports
Current Members Group Address
--------------------------------------------------------------------------------
22 compatible 3 9,10 1-3, 6-7
1,6 235.1.1.1
2,7 234.1.1.1
3 compatible 8 12,13 4,5,8,9
4,8 255.1.1.1
--------------------------------------------------------------------------------
Table 8: Parameters in output of the show ip mvr command
Parameter Meaning
VLAN Multicast VLAN number.
Mode Mode in which IGMP report packets are either sent out through source
ports in the multicast VLAN, (“dynamic”) or not sent out
(“compatible”).s
IMTLEAVE Port number on which the Immediate Leave feature is enabled.
Source ports Uplink ports that send or receive multicast data to and from the
multicast VLAN.
Receiver ports Ports that receive multicast data when they are the member of a
multicast group.
Current Members Receiver ports that are currently members of the multicast group.
Group Address Multicast group IP addresses owned by this multicast VLAN.