Install guide

70 enable pim bsmsecuritycheck Software Reference
enable pim bsmsecuritycheck
Syntax ENAble PIM BSMSecuritycheck
Description This command enables PIM bootstrap message security checking, which
checks that the source IP address of a bootstrap message is the expected
address of the PIM neighbour.
This checking is enabled by default. You may need to disable it when
interoperating with some PIM implementations.
Examples To enable PIM bootstrap message security checking, use the command:
ena pim bsms
Related Commands disable pim bsmsecuritycheck
show pim config
enable pim debug
Syntax ENAble PIM DEBug={ALL|ASSert|BSR|C-Rp-adv|GRAft|HELlo|
JOInt|REGister|STATerefresh}[,...]
Description This command enables debugging options. Debugging may or may not be
enabled already. Debugging information is sent to the port or Telnet session
from which the command was entered. All PIM debugging is disabled by
default.
The debug parameter specifies which debugging options are to be enabled.
The value of this parameter is a single option or a comma-separated list of
options. The following table describes the debugging options.
Examples To enable debugging of PIM hello and join/prune messages, use the command:
ena pim deb=hello,joi
Related Commands disable pim debug
Parameter Description
ALL All debug options.
ASSert PIM Assert packets
BSR PIM Bootstrap packets (Sparse Mode only)
C-Rp-adv PIM Candidate-RP-Advertisement (Sparse Mode only)
GRAft PIM Graft packets (Dense Mode only)
HELlo PIM Hello packets
JOInt PIM Join/Prune packets
REGister PIM Register and Register Stop packets (Sparse Mode only)
STATerefresh PIM State Refresh packets (Dense Mode only)