Install guide

IP Multicasting enable pim 69
enable ip mvr debug
Syntax ENAble IP MVR DEBug={ALL|JOInt|LEAVe|MARL}
Description This command enables the display of debugging messages when specific
actions are taken. The current debug option may or may not be enabled. The
default is enabled.
If all is specified, debugging on all ports is enabled.
If joint is specified, debugging of joint messages is enabled.
If leave is specified, debugging of leave messages is enabled.
If marl is specified, debugging of the MARL table is enabled.
Examples To enable debugging of joint messages on the multicast VLAN, use the
command:
ena ip mvr deb=joi
Related Commands disable ip mvr debug
enable pim
Syntax ENAble PIM
Description This command enables PIM routing on the switch. PIM is disabled by default.
Any existing PIM configuration is activated after this command has been
entered.
Examples To enable PIM routing, use the command:
ena pim
Related Commands add pim bsrcandidate
add pim interface
add pim rpcandidate
disable pim
set pim interface
set pim
show pim