Install guide

IP Multicasting disable pim debug 65
disable pim bsmsecuritycheck
Syntax DISable PIM BSMSecuritycheck
Description This command disables PIM bootstrap message security checking. The switch
stops checking that the source IP address of a bootstrap message is the
expected address of the PIM neighbour.
Bootstrap message security checking is enabled by default. You may need to
disable it when interoperating with some PIM implementations.
Examples To disable PIM bootstrap message security checking, use the command:
dis pim bsms
Related Commands enable pim
show pim config
disable pim debug
Syntax DISable PIM DEBug={ALL|ASSert|BSR|C-Rp-adv|GRAft|HELlo|
JOInt|REGister|STATerefresh}[,...]
Description This command disables the debugging option. The option must currently be
enabled. PIM debugging is disabled by default.
The debug parameter specifies which debugging options are to be disabled.
The value of this parameter is a single option or a comma-separated list of
options. The debugging that results from each of the options is shown in with
the disable pim debug command on page 65.
Examples To disable all PIM debugging, use the command:
dis pim deb=all
Related Commands enable pim debug
show pim debug