Specifications

58 Rapier Series Switch
C613-03020-00 REV K
correctly plugged into the slot on the switch’s base board. Repeat the
installation process, paying particular attention to Step 6.
Use the show system command again, and if the display is still not correct,
contact your authorised Allied Telesis distributor or reseller.
If you have any difficulty with the PAC at any time, contact your authorised
Allied Telesis distributor or reseller and quote the serial numbers of both the
base card on the switch and the PAC. The serial numbers and revision details
can be read using the show system command. It’s a good idea to record this
information for later reference.
Figure 28: Example output from the show system command for a Rapier switch with an
AT-AR061 ECPAC installed
Switch System Status Time 00:23:04 Date
15-Jun-2001.
Board ID Bay Board Name Rev Serial number
--------------------------------------------------------------------------
Base 86 AT-RP24 Rapier 24 M2-1 46690596
NSM 4PIC 87 AT-AR040-00 NSM 4PIC M3-3 6845206
PIC 38 1 AT-AR023-00 PIC Sync M1-1 8618528
PAC 153 AR061 ECPAC P1-16 6844578
--------------------------------------------------------------------------
Memory - DRAM : 32768 kB FLASH : 6144 kB
--------------------------------------------------------------------------
SysDescription
Allied Telesyn AT-RP24 version 2.2.2-00 18-May-2001
SysContact
SysLocation
SysName
SysDistName
SysUpTime
102398 ( 00:17:03 )
Software Version: 2.2.2-00 18-May-2001
Release Version : 2.2.2-00 18-May-2001
Release built : Jun 15 2001 at 05:03:04
Patch Installed : NONE
Territory : europe
Help File : help.hlp
Main PSU : On Main Fan : On
RPS Monitor : Off
Boot configuration file: Not set
Current configuration: None
Security Mode : Disabled
Warning (248283): No patches found.