user manual

AT-MC606 VDSL Network Extender Installation Guide

Selecting a Site for the AT-MC606 VDSL Network Extender

Observe the following requirements when choosing a site for your

AT-MC606 VDSL Network Extender:

 If you plan to install a AT-MC606 VDSL Network Extender into an AT-

MCR12 rackmount chassis and equipment rack, check to be sure that

the rack is safely secured and that it will not tip over. Devices in a rack

should be installed starting at the bottom, with the heavier devices near

the bottom of the rack.

 The AT-MC606 VDSL Network Extender may be wall mounted either

on a DINRAIL using a DINRAIL bracket or using an AT-WLMT bracket.

Both brackets are provide separately. Select a place on the wall that

provides the best cabling and power access.

Note

Both the DINRAIL bracket and the AT-WLMT wall mount bracket are

sold separately. Contact your Allied Telesis Sales representative to

purchase these items.

 If you are installing the AT-MC606 VDSL Network Extender on a table,

be sure that the table is level and secure.

 The power outlet for the AT-MC606 VDSL Network Extender should be

located near the unit and should be easily accessible.

 The site should provide for easy access to the ports on the front of the

AT-MC606 VDSL Network Extender. This makes it easy for you to

connect and disconnect cables, as well as view the LEDs.

 To allow proper cooling of the AT-MC606 VDSL Network Extender, air

flow around the unit and through its vents on the side should not be

restricted.

 Do not place objects on top of the AT-MC606 VDSL Network Extender.

 Do not expose the AT-MC606 VDSL Network Extender to moisture or

water.

 Make sure that the site is a dust-free environment.

 You should use dedicated power circuits or power conditioners to

supply reliable electrical power to the AT-MC606 VDSL Network

Extender.