User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the AT-MWS2533AP Access Point
- Reviewing Safety Precautions
- Unpacking the AT-MWS2533AP Access Point
- Unpacking the AT-BRKT-MWS01 Mounting Base Plate
- Unpacking the AT-MWS0091 AC Adapter Kit
- Installing the Access Point on a Celling or Wall
- Connecting the Access Point with the Ethernet Cable
- Connecting the AC Adapter
- Assembling the AT-MWS0091 AC Adapter
- Installing the AT-MWS2533AP Access Point
- Chapter 3
- Appendix A
MWS Series Access Point Installation Guide
53
Connecting the Access Point with the Ethernet Cable
To connect the access point with the Ethernet cable, perform the following
procedure:
1. Connect the RJ-45 plug into the LAN port as shown in Figure 29.
Figure 29. Connecting the LAN Cable
2. Connect the other RJ-45 plug to the PoE+ switch.