User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the AT-MWS2533AP Access Point
- Reviewing Safety Precautions
- Unpacking the AT-MWS2533AP Access Point
- Unpacking the AT-BRKT-MWS01 Mounting Base Plate
- Unpacking the AT-MWS0091 AC Adapter Kit
- Installing the Access Point on a Celling or Wall
- Connecting the Access Point with the Ethernet Cable
- Connecting the AC Adapter
- Assembling the AT-MWS0091 AC Adapter
- Installing the AT-MWS2533AP Access Point
- Chapter 3
- Appendix A
Chapter 3: Installing the AT-MWS600AP or AT-MWS1750AP Access Point
50
12. Insert the two screws on the access point to the holes on the mounting
base, as shown in Figure 25.
Figure 25. Installing the Access Point onto a Ceiling or Wall
13. Turn the access point until it is securely seated. See Figure 26.
Figure 26. Turning the Access Point to Secure to the Mounting Base
Ceiling T-Rail
Installation
To install the access point on the ceiling T-rail, perform the following
procedure:
What to Prepare for the Rail Installation
You need the following items to install the access point on a ceiling or wall:
AT-MWS600AP or AT-MWS1750AP access point
Two rail clips, either narrow rail clips or wide rail clips
Two spacers
Two long screws for the rail clip with the spacer
Phillips-head screwdriver