User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the AT-MWS2533AP Access Point
- Reviewing Safety Precautions
- Unpacking the AT-MWS2533AP Access Point
- Unpacking the AT-BRKT-MWS01 Mounting Base Plate
- Unpacking the AT-MWS0091 AC Adapter Kit
- Installing the Access Point on a Celling or Wall
- Connecting the Access Point with the Ethernet Cable
- Connecting the AC Adapter
- Assembling the AT-MWS0091 AC Adapter
- Installing the AT-MWS2533AP Access Point
- Chapter 3
- Appendix A
MWS Series Access Point Installation Guide
47
Hard-Surface
Ceiling and Wall
Installation
This section explains how to install the access point on the hard-surface
ceiling or wall.
What to Prepare for the Hard-Surface Ceiling or Wall Installation
You need the following items to install the access point on a ceiling or wall:
AT-MWS600AP or AT-MWS1750AP access point
Two screws to attach to the access point directly
Mounting base
Two screws for the mounting base
Phillips-head screwdriver
Pencil
Note
A Phillip-head screwdriver and pencil are not included in the
shipping box.
Installing the Access Point on the Hard-Surface Celling or Wall
To install the access point on the hard-surface celling or wall, perform the
following procedure:
Note
Attaching the access point to the mounting base may not be easy
once the mounting base is installed on the hard-surface ceiling or
wall. Practice Step 12 and Step 13 before installing the mounting
base on a hard-surface ceiling or wall.
1. Read “Reviewing Safety Precautions” on page 28.
2. Review “Guidelines for Installing the AT-MWS600AP or
AT-MWS1750AP Access Point” on page 46.