User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the AT-MWS2533AP Access Point
- Reviewing Safety Precautions
- Unpacking the AT-MWS2533AP Access Point
- Unpacking the AT-BRKT-MWS01 Mounting Base Plate
- Unpacking the AT-MWS0091 AC Adapter Kit
- Installing the Access Point on a Celling or Wall
- Connecting the Access Point with the Ethernet Cable
- Connecting the AC Adapter
- Assembling the AT-MWS0091 AC Adapter
- Installing the AT-MWS2533AP Access Point
- Chapter 3
- Appendix A
Chapter 2: Installing the AT-MWS2533AP Access Point
40
Assembling the AT-MWS0091 AC Adapter
The AT-MWS0091 AC adapter is shipped with the AC plug for USA
attached. When the AC socket on your wall is other than the USA type,
you can change it to another AC plug for Europe, UK, or Australia.
To change the AC plug on the AT-MWS0091 AC adapter, perform the
following procedure:
1. Select one from the optional AC plugs. See Table 6 on page 32.
2. While pressing the release tab with your thumb, slide the AC plug as
shown in Figure 15.
Figure 15. Detaching the AC Plug from the AC Adapter
3. Remove the AC plug from the AC adapter as shown in Figure 16.
Figure 16. Removing the AC Plug from the AC Adapter
4. Attach the AC plug that you selected to the AC adapter in shown in
Figure 17 on page 41.