User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the AT-MWS2533AP Access Point
- Reviewing Safety Precautions
- Unpacking the AT-MWS2533AP Access Point
- Unpacking the AT-BRKT-MWS01 Mounting Base Plate
- Unpacking the AT-MWS0091 AC Adapter Kit
- Installing the Access Point on a Celling or Wall
- Connecting the Access Point with the Ethernet Cable
- Connecting the AC Adapter
- Assembling the AT-MWS0091 AC Adapter
- Installing the AT-MWS2533AP Access Point
- Chapter 3
- Appendix A
4
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The band from 5600-5650MHz will be disabled by the software during the manufacturing and
cannot be changed by the end user. This device meets all the other requirements specified in
Part 15E, Section 15.407 of the FCC Rules.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 25cm
between the radiator & your body.
Europe - EU Declaration of Conformity
This device complies with Directive 2014/53/EU issued by the Commission of the European
Community.
Radiation Explore Statement
This equipment complies with EU radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Operating Frequencies and Maximum Transmission Power Levels
The operating frequencies and maximum transmission power levels for wireless devices
operated in the EU are listed below:
This device is restricted to indoor use only when operating in the 5150 to 5350MHz frequency
range.
AT-MWS2533AP AT-MWS1750AP AT-MWS600AP
2412-2472MHz 19.92 dBm 19.88 dBm 19.42 dBm
5180-5240MHz 22.97 dBm 22.96 dBm 22.40 dBm
5260-5320MHz 22.90 dBm 22.85 dBm 22.24 dBm
5520-5700MHz 29.89 dBm 29.88 dBm 29.65 dBm