User's Manual

MWS Series Access Point Installation Guide
35
What to Prepare
for the
Installation
You need the following items to install the access point on a ceiling or wall:
 AT-MWS2533AP access point
 AT-BRKT-MWS01 Mounting base plate
 Four screws for a celling or wall
 Phillips-head screwdriver
 Pencil
Note
Screws for the ceiling or wall, a Phillip-head screwdriver and pencil
are not included in the shipping box.
Installing the
Access Point on
the Celling or
Wall
To install the access point on the celling or wall, perform the following
procedure:
Note
Attaching the access point to the mounting base plate may not be
easy once the mounting base plate is installed on a ceiling or wall.
Practice Step 5 to Step 7 before installing the mounting base plate
on a ceiling or wall.
1. Review “Guidelines for Installing the Device on a Celling or Wall” on
page 34.
2. Using the mounting base plate as a template, mark the four holes with
a pencil.
3. Pre-drill the marked locations on the ceiling or wall.
4. Install the mounting base plate on the ceiling or wall as shown in
Figure 9 on page 36.