User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the AT-MWS2533AP Access Point
- Reviewing Safety Precautions
- Unpacking the AT-MWS2533AP Access Point
- Unpacking the AT-BRKT-MWS01 Mounting Base Plate
- Unpacking the AT-MWS0091 AC Adapter Kit
- Installing the Access Point on a Celling or Wall
- Connecting the Access Point with the Ethernet Cable
- Connecting the AC Adapter
- Assembling the AT-MWS0091 AC Adapter
- Installing the AT-MWS2533AP Access Point
- Chapter 3
- Appendix A
MWS Series Access Point Installation Guide
31
Unpacking the AT-BRKT-MWS01 Mounting Base Plate
To unpack the AT-BRKT-MWS01 mounting base palate, perform the
following procedure:
Note
The AT-BRKT-MWS01 mounting base plate is not included in the
AT-MWS2533AP access point package. You must purchase the
mounting base plate separately.
1. Remove the AT-BRKT-MWS01 mounting base palate from the
shipping box and verify the product. See Figure 6.
Figure 6. AT-BRKT-MWS01 Mounting Base Plate
2. Save the packaging material in a safe location.
You must use the original shipping material if you need to return the
unit to Allied Telesis.