User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the AT-MWS2533AP Access Point
- Reviewing Safety Precautions
- Unpacking the AT-MWS2533AP Access Point
- Unpacking the AT-BRKT-MWS01 Mounting Base Plate
- Unpacking the AT-MWS0091 AC Adapter Kit
- Installing the Access Point on a Celling or Wall
- Connecting the Access Point with the Ethernet Cable
- Connecting the AC Adapter
- Assembling the AT-MWS0091 AC Adapter
- Installing the AT-MWS2533AP Access Point
- Chapter 3
- Appendix A
Chapter 2: Installing the AT-MWS2533AP Access Point
30
Unpacking the AT-MWS2533AP Access Point
To unpack the AT-MWS2533AP access point, perform the following
procedure:
1. Remove the AT-MWS2533AP access point from the shipping box.
2. Save the packaging material in a safe location.
You must use the original shipping material if you need to return the
unit to Allied Telesis.
Note
To install the AT-MWS2533AP access point on a ceiling or wall, you
must purchase the AT-BRKT-MWS01 mounting base plate
separately.
Note
To build a redundant power supply system with the power s from the
DC jack, you must purchase the AT-MWS0091 AC adapter kits
separately.