User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Installing the AT-MWS2533AP Access Point
- Reviewing Safety Precautions
- Unpacking the AT-MWS2533AP Access Point
- Unpacking the AT-BRKT-MWS01 Mounting Base Plate
- Unpacking the AT-MWS0091 AC Adapter Kit
- Installing the Access Point on a Celling or Wall
- Connecting the Access Point with the Ethernet Cable
- Connecting the AC Adapter
- Assembling the AT-MWS0091 AC Adapter
- Installing the AT-MWS2533AP Access Point
- Chapter 3
- Appendix A
MWS Series Access Point Installation Guide
23
AT-MWS2533AP The LEDs for the AT-MWS2533AP model display status information as
shown in Table 4.
Table 4. LEDs for the AT-MWS2533AP Access Point
LED State Description
Power Green The access point is powered ON and
operating normally.
Blinking Green The access point is rebooting or
software is upgrading.
Off The access point is not receiving
power.
Blinking Amber The configuration has being reset to
the factory default settings.
LAN 1 Green A valid link is established on the port
at 1000Mbps.
Blinking Green Data is being transmitted/received at
1000Mbps.
Amber A valid link is established on the port
at 10Mbps or 100Mbps.
Blinking Amber Data is being transmitted/received at
10 Mbps or 100Mbps.
Off No link is established.
LAN 2 Green A valid link is established on the port
at 1000Mbps.
Blinking Green Data is being transmitted/received at
1000Mbps.
Amber A valid link is established on the port
at 10Mbps or 100Mbps.
Blinking Amber Data is being transmitted/received at
10 Mbps or 100Mbps.
Off No link is established.
2.4GHz Wi-Fi Green The 2.4GHz Wi-Fi interface is
enabled.
Blinking Green Data is being transmitted/received at
the 2.4GHz frequency band.
Off The 2.4GHz Wi-Fi interface is
disabled.