User Manual

x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
27
System LEDs
The system LEDs on the front panel display general status information.
See Figure 14.
Figure 14. System LEDs
See Table 6 for a description of the system LEDs.
Table 6. System LEDs
LED State Description
FAULT Off Indicates normal operation.
Red Indicates a fault. The switch or the operating
system software has malfunctioned. (Refer to
Chapter 4, “Troubleshooting” on page 55 for
instructions on how to troubleshoot a problem.)
MASTER Off The switch is not a member of an enhanced
stack or has an enhanced stacking status of
slave or unavailable.
Green The switch has an enhanced stacking status of
master.
RPS Off No optional redundant power supply is
connected to the switch.
Green An optional redundant power supply is
physically connected to the switch and may be
powered on or off.
POWER Off The switch is not receiving power.
Green The switch is receiving power.
1313
L/A
50
XFP
LINK / ACT
STATU S
FAU LT
MASTER
RPS
PWR
PRES
MSTR
L/A
L/A
1
2
STACK
CONSOLE
x600-48Ts/XP
BUSY
READY
FAULT
SD
RESET
Layer 3 Gigabit Ethernet Switch