Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1
- Overview
- Chapter 2 :
- Chapter 3
- Chapter 4
- Chapter 5
- Troubleshooting
- Power LED is Off
- Twisted Pair Port Link LED is Off
- SFP or XFP LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Issues with Virtual Stacking Chassis Configuration
- Troubleshooting
- Appendix A
x600 Layer 3 Gigabit Ethernet Switch Installation Guide
95
Transceiver is Installed but the Status is “Not Present”
If a SFP or XFP transceiver is installed in a transceiver slot but the Uplink
Information menu in the AlliedWare Plus Operating System Software
interface displays “Not Present” for that port, do the following:
Verify that the transceiver is completely inserted in the slot on the front
of the switch.
Note
The uplink status does not reflect whether a fiber optic cable is
connected to the transceiver.