Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1
- Overview
- Chapter 2 :
- Chapter 3
- Chapter 4
- Chapter 5
- Troubleshooting
- Power LED is Off
- Twisted Pair Port Link LED is Off
- SFP or XFP LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Issues with Virtual Stacking Chassis Configuration
- Troubleshooting
- Appendix A
x600 Layer 3 Gigabit Ethernet Switch Installation Guide
71
Resetting the Switch
You may need to reset the switch after upgrading the firmware or after you
have made a configuration change that requires resetting the switch to
activate the change.
To reset the x600 switch, perform the following procedure:
1. Locate the RESET button which is on the right hand side of the
faceplate.
2. Press the RESET button with the tip of a pen or a similar
nonconducting object as shown in Figure 33.
Figure 33. Resetting the Switch
1321
x600-24Ts/XP
Layer 3 Gigabit Ethernet Switch
9 11 13 15 17 19 21R 23R
10 12 14 16 18 20 22R 24R
FAU
L
T
RPS
MASTER
PWR
STATUS
21
22
23
24
SFP
L/A
BUSY
READY
FAU LT
SD
RESET
CONSOLE