Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1
- Overview
- Chapter 2 :
- Chapter 3
- Chapter 4
- Chapter 5
- Troubleshooting
- Power LED is Off
- Twisted Pair Port Link LED is Off
- SFP or XFP LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Issues with Virtual Stacking Chassis Configuration
- Troubleshooting
- Appendix A
63
Chapter 3
Installing the Hardware
This chapter provides procedures to install an x600 switch. The chapter
contains the following sections:
“Reviewing Safety Precautions” on page 64
“Unpacking a Switch” on page 67
“Installing the Power Cord Retaining Clip” on page 68
“Installing the Switches in an Equipment Rack” on page 69
“Resetting the Switch” on page 71
“VC Stacking Module Installation” on page 72